RFQ/BOM 0 Se connecter / Registre

Sélectionnez votre emplacement

image de l'utilisateur

What should I do if the success rate of STM32F103 SW interface burning program is low?

MCU
novembre 27, 2020 by Yuri 1642

I use the JLINK+SW interface burning program, but the success rate of JLINK reading ID through the SW interface to connect the chip is very low, and the success rate of the burning program is lower, but sometimes it can be burned in. Most of the cases are mine. When programming the program or connecting the chip, KEIL is stuck, and then it prompts "No Cortex SW Device Found"

Tous les commentaires

user image

Lars Posté sur November 27, 2020

Problem with the line? Or is the usb drive current weak? Try another interface and a shorter cable.

0
user image

Janna Posté sur November 27, 2020

Power supply problems are the most likely, followed by hardware design and cable quality

0
user image

Jessy Posté sur November 27, 2020

It is possible that the two wires of TMS and TCK are a bit long.

0
user image

Benicio Posté sur November 27, 2020

I found that this problem often occurs when using JLink, and the microcontroller is often locked. I have never encountered this problem with STLink.

0

Écrivez une réponse

Vous devez vous connecter pour répondre. Se connecter | Registre